A2P3 PressToCheck™ Filters for the Force™8 Half Mask with Typhoon™ Valve.
How can you be sure that you have donned your mask correctly?
With the new patent pending Force™8 PressToCheck™ filters you can instantly check that you have the correct seal every time.
FIT IT!
Don the Mask - Put the straps and harness over your head and pull the straps to a suitably tight and comfortable fit.
PRESS IT!
PressToCheck™ - Press the front and backs of both filter covers together to stop air from entering through the filters.
CHECK IT!
Inhale - No air should come through the mask. Adjust the mask and repeat until it doesn't. Release when seal is made.
Features & benefits:
- Daily Face Fit Reassurance
- Passes dolomite
- Protection against construction dust
- Improved hygiene
- Inhalation valve for easy maintenance
- Low profile covers protect filters
- Conforms to EN143
PressToCheck™ filters are suitable for protecting your respiratory system from:
- Solvent-based painting
- Water-based painting
- Rubbing down paint
- Paint stripping
- White spirit
- Welding (ferrous and lead)
- Organic vapours and gases
- Dusts
- Mists
- Fibres and fibre glass
- Plaster
- Wood (hard and soft)
- Nuisance odours
How to maintain your Force™ Half-Mask: |
|
Cleaning the mask:
Fitting the mask and "Press to Check" the fit:
Replacing the filters:
Replace the filters periodically. If you start to smell the odour of the paint or it becomes difficult to draw air through the filter, then it is time to replace your cartridges. Preferably replace them before this occurs to ensure you are fully protected.
This short video shows how to fit the filters correctly. The video states the masks come attached as delivered, but please note that our stock is delivered with the face mask and filters separate so you will need to fit the filters as directed the first time.
PLEASE NOTE:
When installing the filters to your mask, please note that the filters do require a reasonable amount of force to be applied to rotate them into the “locked” position. This is to ensure that the gasket between the filters and the mask body is well compressed and therefore sealing the interface efficiently. When carrying out this operation, just take care not to grip the exhaust valve body inside the mask. However, you may hold the overall mask body with the required force to rotate the filters into the “locked” position. Do not twist both filters at the same time.
For more information or advice on this product, please contact us.
Force™8 F-4123 Twin A2P3 - 2 x PressToCheck™ Filters is also available as part of these sets or special offers: |
|
Click on each product for more information |